LT3 Series

L-GAGE

®

Sensors

LT3 Specifications (cont’d) LT3 Specifications

Laser Control Connect red wire to +5 to 24V dc to enable laser beam; connect to 0 to +1.8V dc (or open connection) to disable; when sensor is powered laser enable time is 100 millisecond delay on enable, when sensor is powered. IndicatorsGreen Power ON LED: Indicates when power is ON, overloaded output and laser status Yellow Output LED: Indicates when discrete load output is conducting Red Signal LED: Indicates target is within sensing range and the condition of the received light signal Yellow Speed LED: Indicates the response speed setting Red/Yellow TEACH LEDs: In programming mode; indicate active output(s) ConstructionHousing: ABS/polycarbonate blend Window: Acrylic Quick-disconnect: ABS/polycarbonate blend Environmental Rating IP67; NEMA 6 Connections 2 m or 9 m shielded 7-conductor (with industrial drain) PVC-jacketed attached cable or 8-pin Euro-style quick-disconnect. QD cables are ordered separately. See page 384. Operating ConditionsTemperature: 0° to +50° C Relative humidity: 90% at 50° C (non-condensing) Application Notes • For best accuracy, allow 30-minute warm-up before programming or operating• Retroreflective performance specifications are based on use with supplied BRT-TVHG-8X10P high grade target. Results may vary with other retroreflective target materials. Certifications
R R Hookup DiagramsDiscrete/Analog Models: NPN: MI01 (p. 492) PNP: MI02 (p. 492)
MEASUREMENT & INSPECTION Dual-Discrete Models: NPN: MI03 (p. 492) PNP: MI04 (p. 492)

More information online at

bannerengineering.com 271