| | | | |
| | Supply Voltage and Current | 20 to 250V ac (50/60 Hz). Average current 20 mA. Peak current: 200 mA at 20V ac, 500 mA at 120V ac, 750 mA at 250V ac | |
| | Supply Protection Circuitry | Protected against transient voltages | |
| | Output Configuration | SPST solid-state ac switch; three-wire hookup; Light Operate (LO) or Dark Operate (DO), depending on model. Light operate: Output conducts when the sensor sees its own (or the emitter's) modulated light Dark operate: Output conducts when sensor sees dark | |
| | Output Rating | 300 mA max. (continuous) Fixed-field models: derate 5 mA/° C above +50° C; Inrush capability: 1 amp for 20 milliseconds, non-repetitive Off-state leakage current: less than 100 mA On-state voltage drop: 3V at 300 mA ac; 2V at 15 mA ac | |
| | Output Protection Circuitry | Protected against false pulse on power-up | |
| | Output Response Time | Opposed Mode: 16 milliseconds ON, 8 milliseconds OFF Polarized Retroreflective, Non-polarized Retroreflective, Fixed-field & Diffuse: 16 milliseconds ON/OFF NOTE: 100 millisecond delay on power-up | |
| | Repeatability | Opposed Mode: 2 ms; Polarized Retroreflective, Non-polarized Retroreflective, Fixed-field, and Diffuse: 4 milliseconds Repeatability and response are independent of signal strength. | |
| | Adjustments | T18 Series infrared non-polarized retroreflective and diffuse mode models (only) have a single-turn rear-panel SENSITIVITY control for adjustment of system gain (turn clockwise to increase) | |
| | Indicators | Two LEDs: Green and Yellow Green ON steady: power to sensor is ON Yellow ON steady: sensor sees light Yellow flashing: excess gain marginal (1-1.5x) in light condition | |
| | Construction | Housings are thermoplastic polyester. Lenses are polycarbonate or acrylic; T18 models come with one jam nut. | |
| | Environmental Rating | Leakproof design rated NEMA 6P, DIN 40050 (IP69K) | |
| | Connections | 2 m or 9 m attached cable, or 4 pin Micro-style quick-disconnect fitting. QD cables are ordered separately. See page 386. | |
| | Operating Conditions | Temperature: -40° to +70° C Relative humidity: 90% at 50° C (non-condensing) | |
| | Vibration and Mechanical Shock | All models meet Mil. Std. 202F requirements. Method 201A (Vibration; frequency 10 to 60 Hz, max, double amplitude 0.06-inch acceleration 10G). Method 213B conditions H&I (Shock: 75G with unit operating; 100G for non-operation) | |
| | Certifications | C € «• ® | |
| | Hookup Diagrams | Cabled Industrial emitters: AC03 (p. 484) Other cabled Models: AC05 (p. 485) QD Emitters: AC07 (p. 485) Other QD Models: AC06 (p. 485) | |
| | | | |