Text version of the page

Q60 Series

Fullsize Sensors

Fullsize Sensors - 7106 Q60 Specifications (cont’d) Q60 Specifications

Indicators (cont’d) Q60LAF models:ON-Delay Green ON Steady: RUN mode, ON-delay active Green Flashing: ON-Delay Selection mode OFF-Delay Green ON Steady: RUN mode, OFF-delay active Green Flashing: OFF-Delay Selection mode
PHOTOELECTRICS Note: outputs are activeduring on/off timing selection mode. 5-Segment Light Bar* Indicates relative delay time during ON or OFF Delay Selection modes RUN Mode: Output Yellow ON Steady: Outputs are conducting Green ON Steady: ON/OFF-Delay Selection Dark Operate Green ON Steady: Dark Operate selected Lockout Green ON Steady: Buttons locked out Light Operate Green ON Steady: Light Operate selected Signal Green ON Steady: Sensor receiving signal Green Flashing: Marginal signal (1.0 to 2.25 excess gain) * Output, Dark Operate, Lockout, Light Operate and Signal indicators function as 5-Segment Light Bar during ON or OFF Delay Selection modes Laser CharacteristicsSpot Size: approximately 4 x 2 mm throughout range (collimated beam) Angle of Divergence: 5 milliradiansNOTE: Contact factory for custom laser spot size. ConstructionHousing: ABS polycarbonate blend Lens: acrylic Cover: Clear ABS Environmental Rating IEC IP67; NEMA 6 Connections 2 m or 9 m integral cable. DC models offer a 5-pin Euro-style QD fitting. AC models offer 4-pin Micro-style QD fitting. QD cables are ordered separately. See pages 382 and 386. Operating ConditionsTemperature: Q60BB6LAF (DC) models: -10° to +50° C Q60VR3LAF Universal models: -10° to +45° C All other models: -20° to +55° C Relative humidity: 90% at 50° C (non-condensing) Certifications LED Models: Laser Models: Hookup DiagramsDC Models: DC11 (p. 478) Universal Cabled Models: UN01 (p. 487) Universal QD Models: UN04 (p. 487)

Class 1 Lasers Class 2 Lasers

Lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical instruments for intrabeam viewing. Reference 60825-1 Amend. 2 © IEC:2001(E),section 8.2. Lasers that emit visible radiation in the wavelength range from 400 nm to 700 nm where eye protection is normally afforded by aversion responses, including the blink reflex. This reaction may be expected to provide adequate protection under reasonably foreseeable conditions of operation, including the use of optical instruments for intrabeam viewing. Reference 60825-1 Amend. 2 © IEC:2001(E), section 8.2.

For safe laser use:

• Do not permit a person to stare at the laser from within the beam. • Do not point the laser at a person’s eye at close range.• Locate open laser beam paths either above or below eye level, where practical.

For safe laser use:

• Do not permit a person to stare at the laser from within the beam. • Do not point the laser at a person’s eye at close range.• Locate open laser beam paths either above or below eye level, where practical.

162

More information online at

bannerengineering.com