Text version of the page

OMNI-BEAM

™

Series

Fullsize Sensors

PHOTOELECTRICS

Fullsize Sensors - 7106 OMNI-BEAM

™

Sensor Head Specifications

Supply Voltage and Current Supplied by OMNI-BEAM power block. See page 156. Output Response Time See individual sensing heads for response times (see pages 154 and 155).200 millisecond delay on power-up: outputs are non-con duct ing during this time. Adjustments OMNI-BEAM sensor heads are field-programmable for four operating parameters. A set of four programming DIP switches is located at the base of the sensor head and is accessible with the sensor head removed from the power block SWITCH #1 selects the amount of sensing hysteresis SWITCH #2 selects the alarm output configuration SWITCH #3 selects Light Operate (switch #3 OFF) or Dark Operate (switch #3 ON) SWITCH #4 selects the STANDARD (switch #4 OFF) or Fine (switch #4 ON) scale factor for the D.A.T.A. light signal strength indicator array Sensitivity: 15-turn slotted brass screw Gain (sensitivity) adjustment potentiometer (clutched at both ends of travel). Indicators Construction Sense and Load indicator LEDs are located on the top of the sensor head on either side of the D.A.T.A. array.Sense LED indicates when a target has been sensed Load LED lights whenever the load (sensor output) is energized Also, Banner’s exclusive, D.A.T.A. sensor self-diagnostic system located on the top of the sensor head warns of marginal sensing conditions usually before a sensing failure occurs (except on model OSBFAC) Sensor heads are molded of rugged thermoplastic polyester; top view window is polycarbonate; acrylic lenses; stainless steel hardware. Environmental Rating Meets NEMA standards 1, 2, 3, 3S, 4, 12, and 13; IEC IP66 when assembled to power block. Operating ConditionsTemperature: -40° to +70° C Relative humidity: 90% at 50° C (non-condensing) Certifications

OMNI-BEAM

™

Timing Logic Module Specifications

Response Time A disabled timing function adds no measurable sensing response time Timing Adjustments All logic modules feature 15-turn clutched potentiometers for accurate timing adjustments. The logic module slides into the sensor head housing and interconnects without wires. Timing adjustments are easily accessible at the top of the sensor head and are protected by the sensor’s transparent cover. Timing Repeatability ± 2% of timing range (max.); assumes conditions of constant temperature and power supply Time Range Useful range is from maximum time down to 10% of maximum (all models); when timing potentiometer is set fully counterclockwise, time will be approximately 1% of maximum for models OLM5 and OLM8, and 2% of maximum for model OLM8M1 Operating ConditionsTemperature: -40° to +70° C Relative humidity: 90% at 50° C (non-condensing) Certifications

More information online at

bannerengineering.com 157