Text version of the page

MINI-BEAM

®

Expert

™

Ser i es

Compact Sensors

Compact Sensors - 7106 MINI-BEAM

®

Expert

™

Specifications

PHOTOELECTRICS Supply Voltage and Current 10 to 30V dc (10% max. ripple) at less than 45 mA, exclusive of load Supply Protection Circuitry Protected against reverse polarity and transient voltages Output ConfigurationBipolar: One current sourcing (PNP) and one current sinking (NPN) open-collector transistor. Configuration in TEACH sequence for Light Operate (LO) or Dark Operate (DO). Output Rating 150 mA max. each output at 25° C, derated to 100 mA at 70° C (derate 1 mA per ° C) Off-state leakage current: less than 5 µA @ 30V dc Output saturation voltage (PNP output): less than 1 volt at 10 mA and less than 2 volts at 150 mA Output saturation voltage (NPN output): less than 200 millivolts at 10 mA and less than 1 volt at 150 mA Output Protection Circuitry Protected against false pulse on power-up and continuous overload or short-circuit of outputs Output Response Time Sensors will respond to either a “light” or a “dark” signal of 500 microseconds or longer duration, 1 kHz max. NOTE: 1 second delay on power-up; outputs do not conduct during this time. Repeatability 100 microseconds (all models) Adjustments Push-button TEACH mode sensitivity setting; remote TEACH mode input is provided (gray wire) IndicatorsTwo LEDs: Yellow and Bicolor Green/Red Green (RUN Mode): ON when power is applied Flashes when received light level approaches the switching threshold Red (TEACH Mode): OFF when no signal is received. Pulses to indicate signal strength (received light level). Rate is proportional to signal strength (the stronger the signal, the faster the pulse rate). This is a function of Banner’s Alignment Indicating Device (AID). Yellow (TEACH Mode): ON to indicate sensor is ready to learn output ON condition OFF to indicate sensor is ready to learn output OFF condition Yellow (RUN Mode) : ON when outputs are conducting Construction Reinforced thermoplastic polyester housing, totally encapsulated, o-ring seal, acrylic lenses, and stainless steel screws. Environmental Rating Meets NEMA standards 1, 2, 3, 3S, 4, 4X, 6, 12, and 13; IEC IP67 Connections PVC-jacketed 5-conductor 2 m or 9 m unterminated cable, or 5-pin Euro-style quick-disconnect (QD) fitting are available. QD cables are ordered separately. See page 382. Operating ConditionsTemperature: -20° to +70° C Relative humidity: 90% at 50° C (non-condensing) Application Notes The first condition presented during TEACH mode becomes the output ON condition. Certifications Hookup Diagrams DC11 (p. 478)

More i nformat i on onl i ne at

bannereng i neer i ng . com 83