Text version of the page

Lake MonitorsPneumatic Flow Rate Monitors Lake Monitors Pneumatic Flow Rate Monitors

Ideal for monitoring air compressor outputs, pneumatic tool air consumption and industrial gas flows.

FOR 1/8" – 2" PIPE SIZES STYLEG

CHOICE OF THREE MATERIALS OF CONSTRUCTION HIGH PRESSURE OPERATION The magnetically coupled follower and rigid pres-sure vessel design allows operation to 1000 PSIG. Select from aluminum, brass or stainless steel tomeet system and media compatibility requirements. 24 DIFFERENT PORTS AVAILABLE UNRESTRICTED MOUNTING Standard selection of NPT, SAE and BSP portsreduces the amount of adapters required for installation. Allows the designer to install the monitor in anyorientation — horizontal, vertical or inverted. LOW COST ACCURACY ±2.5% of range accuracy in center third of scale;±4% in upper and lower thirds SUPERIOR EXTERIOR DESIGN Weather-tight for use outdoors and/or on systemswhere wash downs are required. BI-DIRECTIONAL AND REVERSE FLOWOPTION OFFERED RUGGED AND RELIABLE Pneumatic monitors are also available in bi-directional and reverse flow versions. Contact Lake Monitors for more information. These monitors are constructed with all metalpressure vessels, allowing safe, permanent installation in industrial systems.
ENGINEERING SPECIFICATION THE PNEUMATIC IN-LINE FLOW RATE MONITOR SHALL: ? Use the variable annular orifice technique with compression spring recoil. ? Not require inlet or outlet straight plumbing, or require vertical pipe mounting. ? Have a measuring accuracy of ±2.5% of full scale in the center third of the measuring range, and ±4% in upper and lower thirds. ? Have a stainless steel sharp-edged orifice. ? Have a weather-tight external construction. ? Be Lake Monitors No. G _ _ – _ _ _ – _ _

www.lakemonitors.com