SiNet Hub 444 Multi-Axis Motion Hub with I/O - Applied Motion Products - #1

404 Westridge Dr. • Watsonville, CA 95076 831/761-6555 • 800/525-1609 • FAX 831/761-6544 www.appliedmotionproducts.com

• Networks all Applied Motion Stepper or Servo Si™ products for multi-axis motion applications

• For real time execution of commands down­loaded from a host PC or PLC using Applied Motion's Si Command Language™ (SCL)

• Programmable for stand alone single or multi-axis operations with Applied Motion's easy to use SiNet Hub Programmer™ Windows software (software and programming cable included)

• Communication via RS232

• Four optically isolated programmable inputs

• Four optically isolated programmable outputs

• Optional DIN rail mounting kit

The SiNet™ Hub 444 allows up to 4 Stepper or Servo Si™ drives to be controlled in host mode from a single PC or PLC's RS-232 serial port or will run in stand-alone mode.

Each indexer-drive acquires its unique address from the port to which it is connected. This simple ad­dressing scheme minimizes the cost of the drives, and more importantly, the cost of configuring and/or replacing drives in your system. Connections are made with low cost, reliable telephone cabling.

Any of our popular, cost effective programmable Stepper or Servo Si™ drives or Si™ motor controls can be used with the SiNet™ Hub 444. By choosing the power level and features you need for each axis of your application, SiNet™ can provide a cost ef­fective single or multi-axis motion solution.

The SiNet™ Hub 444 is powered by the drive that's connected to port #1, saving you the cost and in­stallation expense of using a separate power sup­ply. Our Si™ Command Language (SCL) allows a host PC or PLC to execute relative, absolute and homing moves, make status inquiries, sample in­puts, set outputs, and more.

If your application requires a single axis to operate In "host mode", you can connect any of our pro­grammable Si™ drives directly to your PC via the SiNet Hub 444 and invoke the Si™ Command Lan­guage (SCL).

Our SiNet Programmer™ Windows software allows the user to create and store multi-axis motion con­trol programs in the SiNet™ Hub 444 and run them without a PC. Thus allowing the user to create a complex multi-axis motion system controlled from an operator interface or trigger.

Control Si-100