Text version of the page

NETWORK ANALYZERS

Specifications Ordering information

General measurement and enhancement display capabilities are thesame as those for the MS4622A/B/D, MS4623A/B/D, MS4624A/B/D. Please specify model/order number, name, and quantity when ordering.

Model/Order No.Name Number of channelsFour measurement channels Mainframe Operating port power –5 dBm for 0.1 dB compression(A1, A2, B1 and B2) MS4622C10 MHz to 3 GHz direct receiver access MS4623C10 MHz to 6 GHz direct receiver access MS4624C10 MHz to 9 GHz direct receiver access Options Option 1Rack mount kit with slides Option 2Time domain Option 3CAdds to MS4622C a 2nd internal source (3 GHz source) + 3rd portOption 3DAdds to MS4623C a 2nd internal source (6 GHz source) + 3rd portOption 3FAdds to MS4624C a 2nd internal source (9 GHz source) + 3rd portOption 4D Maximum port power +20 dBmfor no damage –110 dBm@10 Hz IF bandwidth (<3 GHz), typically >–120 dBm in narrowband sweep;Noise floor–100 dBm@10 Hz IF bandwidth (>3 GHz), typically >–110 dBm in narrowband sweep System dynamic range97 dB Power output rangeMS4622C: +10 to –85 dBm(ports 1, 2 and 3)MS4623C: +7 to –85 dBmMS4624C: +7 to –85 dBm
∗ 3 Noise figure 50 MHz to 3 GHz (only for C models)Option 4E
∗ 3 Source match–9 dB (uncorrected)(RF1, RF2 and RF3) Noise figure 50 MHz to 6 GHz (only for C models)Option 5Frequency translated group delay Option 63rd test port (only for B and C models)Option 7T/R step attenuator (only for A models, standard on B)Option 8 Port match–12 dB (uncorrected)(A1, A2, B1 and B2)
∗ 1 Harmonic measurementOption 11 MS4622C: 10 MHz to 3 GHzFrequency rangeMS4623C: 10 MHz to 6 GHzMS4624C: 10 MHz to 9 GHz
∗ 2 Test Port connectorOption 13Intermodulation distortion Noise sources 2nd internal sourceOptional NC346A5dB ENR noise source (3.5 mm) NC346B15dB ENR noise source (3.5 mm) Intermodulation DistortionOptional IMD (3rd order)70 dB with 10 Hz IF bandwidth @ 300 kHzdynamic rangetone separation and @ –20 dBm tone levels

∗

1:Subject to frequency range limitations imposed by test set.

∗

2:Standard connector is N-female, no cost option for 3.5 mm (male), 3.5mm (female), N-male, or GPC-7. IMD accuracy±1 dB @ > –60 dBm levels Power measurement±1 dB without flat power calibrationaccuracy±0.1 dB with flat power calibration ∗ 3: Does not include noise source. Full reversingProvidedtransfer switch

http://www.anritsu.com 536