Text version of the page

HANDHELD MEASURING INSTRUMENTS

Distance-To-FaultSmith Chart

Performance Specifications

Frequency Range 2 to 4000 MHz (MS2024A)2 to 6000 MHz (MS2026A) Frequency Accuracy 25 ppm Frequency Resolution
∗ 1 10 kHz Data Points Low, Medium, High (137/275/551) On-Channel +17 dBm Interference Immunity
∗ 2 On-Frequency +10 dBm (RF Out), +30 dBc RF In Frequency 1-Port Power High 0 dBm (typical) High 0 dBm (typical) 2-Port Power Low –35 dBm (typical) Corrected Directivity
∗ 3 42 dB (2 MHz to 6 GHz
-E ∆ /20 1-Port Accuracy
∗ 3 = <0.8 + |20 log(1 ±10 )| dB, typicalE ∆ = Directivity – Measured Return Loss 80 dB, 2 MHz to 3 GHz70 dB, >3 GHz to 5.5 GHz 65 dB, >5.5 GHz to 6 GHz System Dynamic Range Range 0 to 60 dB Return Loss Resolution 0.01 dB Range 1 to 65 VSWR Resolution 0.01 Range 0 to 30 dB Cable Loss Resolution 0.01 dB Range –180°to +180° 1-Port Phase Resolution 0.01° Smith Chart Resolution 0.01 Range –120°to 100 dB 2-Port Gain Resolution 0.01 dB Range –180°to +180° 2-Port Phase Resolution 0.01° Fault Resolution (meters) (1.5 x 10
8 x vp)/ ∆ F vp is the propagation constant and ∆ F is F2-F1 in Hz Distance-to- Fault (DTF) Horizontal Range (meters) Horizontal Range (meters): 0 to (data points-1) x Fault Resolution to a maximum of 1500m (4921 ft) where datapoints = 137/275/551 Vertical Range (Return Loss) 0 to 60 dB Vertical Range (VSWR) 1 to 65

∗

1:If display resolution (Span / (DataPoints-1)) is less than 150 kHz, then frequency resolution only applies to measurements with RF Immunity set to Normal.

∗

2:On Channel Interference Immunity is specified at >1.0 MHz of the carrier frequency.On-Frequency Interference Immunity is specified to within ±10 kHz of the carrier frequency.

∗

3:All accuracy and directivity specifications apply only when using Anritsu’s precision components.

http://www.anritsu.com 396