Complete marine program

AMETEK Calibration Instruments offers a complete program of marine approved temperature, pressure, and signal calibrators, including a broad selection of marine approved temperature sensors

Increasing demands Maintain and calibrate monitoring devices for: The International Safety Management code is adopted by IMO and is made mandatory for a selection of vessels. On July 1, 2002 the SOLAS chapter IX and the ISM code was applied to ships, including mobile offshore drilling units. Furthermore, the increasing energy prices have raised the demand for optimal operation on board. The high energy prices make maintenance and calibration a good investment - with a short pay back time. Local, regional and international regulations for emission and pollution are becoming more and more frequent and call out for calibration to ensure optimal and cost effective operation. DNV approval Turbo-charger lubrication • Lubricating oil systems • Cylinder / piston / fuel valve cooling medias • Fuel oil inlet • Scavenge air • Exhaust gas • Sea water cooling • Thrust / shaft plane / stern tube bearings • Crankcase protection • Charge air • Turbine and gear bearings • Uptake gas • Steam • Feed water • Servo oil propeller pitch • Cooling water outlet • Purifiers • Refrigeration systems • Starting air • Gland steam • Hydraulic systems • Condensing system • Oil burner • Main steam • Generators • Condensers • Safety valves All JOFRA calibrators in this brochure have a marine type approval certificate from Det Norske Veritas. FP Temperature Sensors have marine approvals from Lloyds Register of Shipping and Det Norske Veritas.

10 good reasons to calibrate on board a ship

• To obtain traceability• To effectively satisfy the IMO, SOLAS, ISM codes, etc.• To meet requirements from classification companies • To meet safety regulations • To achieve optimum machine operation and efficiency• To reduce unexpected repair and replacement• To prevent turndowns of machinery• To reduce pollution• To save energy• To save money

Renewal of certificates and re-calibration facilities are offered from all our sales and service offices

AMETEK Denmark A/S Headquarters for AMETEK Calibration Instruments. Responsible for sales, support and service globally. Manufacturer of JOFRA calibration instruments and FP temperature sensors. AMETEK China Local offices in Beijing, Shanghai and Guangzhou. Responsible for sales, support and service in China, Taiwan and Vietnam. AMETEK Mansfield & Green Responsible for sales, support and service in North America. Manufacturer of the M&G deadweight testers and pumps. AMETEK Lloyd Instruments AMETEK GmbH AMETEK Singapore Responsible for sales, support and service in the UK. Responsible for sales, support and service in Germany. Responsible for sales, support and service in Singapore. 2 www.jofra.com