UPM315 - DIN 96x96 and ANSI 4” Power counting

Specifi cations

Switched mode power supply Voltage inputs Rated voltage: 65 - 250 Vac 50/60Hz or 90 - 250 Vdc (19 - 60 Vdc - option) Consumption: 5VA max Maximum measurable voltage: 600 (750)V Current inputs
AC max L-LInput impedance: >1.3 MOhm Burden: max 0.15 VA per phase Frequency: 45 - 65 Hz Rated current (Ib): 1 / 5 A
RMS programmableMin / max measurable current: 20 mA / 7 A
RMS Maximum overload: 10A
RMS continuous - 100 A
RMS for 1 sec.Input impedance: 0.02 Ohm approximately Burden: max 0,5 VA per phase Insulation voltage: 150 V Display and operating controls Data memory Display: Backlighted graphic LCD display 160 x 144 dots Keypad: 5 push-buttons Type: On-Board non-volatile FLASH, 128kB or 2 MB
AC max between phases Typical accuracy Communication port Real Time Clock Voltage: ± 0.1% reading ± 0.03% full scale Current: ± 0.1% reading ± 0.05% full scale Active power: ± 0.5% reading ± 0.1% full scale (PF=1) Power factor: 1% reading (0.5 inductive - 0.8 capacitive) Active energy: 1% reading (0.5 inductive - 0.8 capacitive) Frequency: ± 0.05% reading ± 1 digits from 45 to 65 Hz Type: No.1 selectable RS232 or RS485, optoisolated No.1 available for plug-in comm. boards Baud Rate: 300 to 57600 bps Type: with battery backup Accuracy: ± 30 ppm Digital outputs Type: No.2 isolated Optomos (50V - 300mA Single-Phase up to 400V TYPICAL WIRING DIAGRAMS 3-Phase 4-Wire up to 600V 3-Phase 3-Wire above 600V
AC-DC ) Standards compliance Environmental conditions Safety: UL recognized under UL61010B-1and CAN/ CSA-C22.2 No. 1010.1-92, 73/23/EEC, 93/68/EEC directives, EN61010.1 EMC: 89/366/EEC directive and following modifi cations 93/31/EEC and 93/68/EEC, EN50081-2, EN50082-2, EN61326/A1 Operating temperature: from -15
o C to +60
o CStorage temperature: from -25
o C to +75
o CRelative humidity: 80% max. without condensation Mechanical characteristics Material: Metal enclosure Protection degree: IP54 (front panel); IP20 (terminals) Terminals: Pluggable terminal blocks suppliers (Barrier terminal strips - OPTION) Size / Weight: 96 x 96 x 130 (mm) DIN version 750 gr 110 x 110 x 40 (mm) ANSI Display 390 gr 90 x 90 x 130 (mm) Transducer 800 gr
ENERGY MEASUREMENT AND CONTROLwww.algodue.com