catalogue search
P. 01
P. 02
P. 03
P. 04
|
|
|
|
You may also be interested in
Condition monitoring system, Noise analyzer, Monitoring device, Vibration meter, Calibrator
Text version of the page
| | ||||
| Adash 4201 diagnostics analyser Application: l& The diagnostic analyser for service measurement, analysis before and after repair etc. & Diagnostics of bearings, lubrication and mechanical defects of machines - unbalance, misalignment... & Diagnostics of ventilators, pumps, gearboxes, engines, turbines, machine tools... & Diagnostics of low-speed machines - paper machines, rolling mills, transport mechanisms... & Operating machine balancing & Run-up and run-out analysis & Check-out of production & Eex ibllBT3 certificate | ||||
| | ||||
| Characteristics: & 1or2 (option) channel instrument & A possibility to connect acceleration, velocity sensors, optical phase probe or any voltage signal +/- 3V & ICP powering of the connected sensor, AC input for general measurement & TTL trigger for the synchronization of measurement, machine speed measurement & Averaging of static and dynamic data measurement, maximum 20 & Measurementof TRUE-RMS, TRUE-PEAK values, Crestand Kurtosis in paths: LF velocity in mm/s in band 10 to 1000 Hz LIN acceleration in m/s2 in band 0.8 Hzto 16 kHz 200Hz acceleration in m/s2 in band 0.8 to 200 Hz HFE acceleration in g (9.81 m/s2) in band 1.5 to16 kHz ENV envelope in g (9.81 m/s2) in band 1.5to 16 kHz & FFT analysis 101 to 801 lines, order analysis of 10 harmonics & Time signal analysis & Operating single or two plane balancing & Run-up and coast down measurements, controled by time or machine speed & On-line data saving, data memory 512 kB & Backlighted graphic LCD display & Power supply 4 x AA batteries or alkaline cells & RS 232 interface for communication with the user software & User software A4000 Download, DDS 2000, MDS 5.00 | ||||
| | ||||
| Introduction: The Adash 4201 instrument is a portable, fully digital balancing and vibration analyser with the possibility of on-line measurements and data storage. It is intended for identification of bearing condition, lubrication and mechanical defects of machines. It provides diagnostics by the measurement of overall values, FFT analyses and time signals. This equipment enables not only the detection of defects but also | the detailed analysis and precise specification. It can also be used for single and two plane machine balancing and for run-up and run-out measurements The analyser is particulary easy to use. If used with the DDS 2000 database and expert system, it is suitable for both experienced users and beginners. It can also be used with our simple A4000Download software. | If used with the MDS 5.00 software, it can be used for creating machine deflection shapes. Diagnostics of Bearings condition and Lubrication: For this diagnostics, the Adash 4201 instrument offers HFE methods, envelope analysis and Crest and Kurtosis factor measurement. The measurement of HFE parameter is the basic method for the analysis of antifriction bearings. It is based on the fact that, in case | ||
| | ||||
| ADASH Ltd., Ostrava, Czech Republic, tel.: +420 596 232 670, fax: +420 596 232 671, email: info@adash.cz For further technical and contact information consult www.adash.net, www.adash.cz | ||||
| | ||||