catalogue search
P. 01
P. 02
P. 03
P. 04
|
|
|
|
You may also be interested in
Vibration monitoring system, Vibration meter, Condition monitoring system, Analysis software, Data-logger
Text version of the page
| | ||||
| Adash 4101 vibration analysers | ||||
| | ||||
| Application: l& Diagnostics of bearings, lubrication and mechanical defects of machines - unbalance, misalignment... & Diagnostics of ventilators, pumps, gearboxes, engines, turbines, machine tools... & Diagnostics of low-speed machines - paper machines, rolling mills, transport mechanisms... & Operating machine balancing & Check-out of products & Eex ibllBT3 certificate | ||||
| | ||||
| Characteristics: & A possibility to connect acceleration, velocity sensors an optical phase probe, a measuring transformer & ICP feeding of the connected sensor, AC input for general measurement & TTL trigger for the synchronization of measurement, machine speed measurement & Averaging of static and dynamic data measurement maximum 64 & Measurement of TRUE-RMS and TRUE-PEAK values, Crest and Kurtosis factors LF velocity in mm/s in band 10 to 1000 Hz LIN acceleration in m/s2 in band 0.8 Hzto 16 kHz HF acceleration in g (9.81 m/s2) in band 5to 16 kHz ENV envelope in m/s2 in band 5 to16 kHz & FFT analysis 101 to 801 lines, order analysis of 10 harmonics & Time signal analysis & Operating single or two plane balancing & Data collector - route mode of measurement, data memory 512 kB & Analyser - user setting of parameters between measurements & Backlighted graphic LCD display & Power supply 4 x AA batteries or alkaline cells & RS 232 interface for communication with the user software & User software A4000 Download, DDS 2000, MDS 5.00 | ||||
| | ||||
| Introduction: The Adash 4101 instrument is a portable, fully digital data collector and vibration analyser with the possibility of on-line and route measurements. It is intended for identification of bearing condition, lubrication and mechanical defects of the whole machine. It enables to apply diagnostics at the level of measurement overall values, FFT analyses and time signal measurement. Its equipment enables not only detection of occurring defects but also their detailed analysis and precise specification. It can also be used for | single and two plane machine balancing. The analyser is characteristic by its very easy operation. If used with the DDS 2000 database and expert system, it is suitable for both experienced users and beginners. Also is possible to use simple A4000Download software. If used with the MDS 5.00 user software, it enables to evaluation the machine deflection shapes. Diagnostics of Bearings and Lubrication: For this diagnostics, the Adash 4101 instrument offers HFE methods, | envelope analysis and Crest and Kurtosis factor measurement. The measurement of HFE parameter is the basic method for the analysis of antifriction bearings. It is based on the fact that, in case of an incipient defect, the emitted energy of vibrations increases in higher frequencies (kHz levels). This parameter is also very sensitive to lubrication failures. The analyser enables to measure TRUE-RMS and TRUE-PEAK values, time signal and signal spectrum in frequency bands HF and LIN (vide the Technical Specification on the final page). | ||
| | ||||
| ADASH Ltd., Ostrava, Czech Republic, tel.: +420 596 232 670, fax: +420 596 232 671, email: info@adash.cz For further technical and contact information consult www.adash.net, www.adash.cz | ||||
| | ||||