Gas & Pump Line Heaters & Controllers - A&N Corporation - #19

Text version of the page

table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:14.00pt "Arial", sans-serif; } .font1 { font:22.00pt "Arial", sans-serif; } .font2 { font:12.00pt "Georgia", serif; } .font3 { font:10.00pt "Impact", sans-serif; } .font4 { font:11.00pt "Impact", sans-serif; } .font5 { font:12.00pt "Impact", sans-serif; } .font6 { font:15.00pt "Impact", sans-serif; } .font7 { font:16.00pt "Impact", sans-serif; } .font8 { font:17.00pt "Impact", sans-serif; } Gas Line Heaters and Insulators Section 15 High Vacuum Components Since 1965 A&N CORPORATION Gas Line Heating Unrform heating of gas hnes prevents condensation ot gases due to phase shitt at tow températures. The condensation occurs in the gas line and puddle in the shower hsad before being injected into the vacuum chamber. Ths optimum line température to prevent condensation will vary depending on the process parameters. Agency Certification, Récognition Compliance and Approvals • UL° Recognized for US. and Canadian safety standards • Heaters and Insulators meet UL94-HB llammability requirements Uate*N*Lock* is a registered trademark ot AMP JL# is a registered trademark of Underwriters Laboratories, Inc. Waming: Thèse heaters are not designed lor hazard-ous locations or for outdoor locations. They are not designed for total or partial immersion and should only be installed on grounded metallic tubing Systems or GFI protected circuit I.D. available: 14-(6mm). 38'(13mm), W (19mm) Materials: Heater and Jacfcet - Reinforced Silicone rubberfabric Insulation - silicone rubber sponge Colon Outer Jacket-Green Insulation - Grey Heater * Greeo Nominal thickness: 36* (10mm) Fasteners: snap type» métal construction. 516* (8mm) nominal diameter Maximum operating température 200T Available with a built-in type J thermocouple Connectors: Positive locking AMP Universal Mate* N-Lock* Connecter Heater leads have a maie plu g on one end and a lemale cap on the other end Leads extend 3* past each end of the heater Insulators are trim-to-frt for complète line coverage. Available in straight tee and elbow Electrical Spécifications 120V-ac Standard other voltages available Watt Density: 2.5W/in* (0.39 W/cm*) on gas lins O.D. Silicone Rubber Outer Jacket Optional Thermocouple Heaters are connectable up to a 10 amp circuit Snap astener Heating" ^SS^™^, < Silicone Rubber Silicone Sponge Insulation AH ® Registered Trademarks are the property of their respective compan (352) 528-4100 • 1(800) FLANGE1 • www.ancorp.com Intro. pg. 7. 15.19