catalogue search
P. 01
P. 02
P. 03
P. 04
P. 05
P. 06
P. 07
P. 08
P. 09
P. 10
P. 11
P. 12
P. 13
P. 14
P. 15
P. 16
P. 17
P. 18
P. 19
P. 20
P. 21
P. 22
P. 23
P. 24
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You may also be interested in
Analyzer, Multifunction calibrator, Hand-held analyzer, Detector, Network analyzer
Text version of the page
| Technical Data | REG-D™ | |||||||||||||||||||||||||||||||||||||||||||||||
| 1 Limit value monitoring for all measurement quantities 1 4 freely programmable set-point values 1 Rated values of U and I can be programmed ' Implementation of control tasks through ability to freely program 1 RS485 peripheral bus (COM3) for- addit cnal interface modules [ANA-D, BIN-D) 1 ParaGramer lunction for the display and automation of any parallel conniptions with jp lo ten Iran:;formers 1 WinREG parameterisation software for parameterisation, programming and visualisation as well as for a PC-based archiving and evaluation of the recorder data 1 REGSim'" simulation software for the si any parallel operation, network an | Regulator mode The actual value and a fixed or load-dependent setpoint value are compared in the regulator. I as comparison determines the correcting variable "o- the *aa-cnaager of the transformer. dependent on in......la: ve................ametai ■ U ■ icgulatO' can ba ootr'aliy adiastoa aoco'diri:;: lo tat: dynamo fins beravioui ot tho nelvvo'k voltage in o'de-1 k; obtain nigh control performance at a low number of switching operaSons, | |||||||||||||||||||||||||||||||||||||||||||||||
| jf transformers Every regulator can be used with other regulators from the I iHGSy:: '■' 'airily to rcoaalo .in lo ' C tanolor-ters connected in parallel without additional components. | ||||||||||||||||||||||||||||||||||||||||||||||||
| Various nrocessos :a; aval able to oonl'i they are isted in Table 1 according to those that operate in parallel on a busbar and those that are simply freely sv/iichea in parallel. An essential factor in this cortex: is Mat no additional components are required as all function units requnea for parallel operation are accommodated within the regulators. | ||||||||||||||||||||||||||||||||||||||||||||||||
| ■e REG-D™ regulator | ||||||||||||||||||||||||||||||||||||||||||||||||
| ' 2x current and 2x voltage transformers 2 Analogue mA inputs, Pt 100 3 Binary inputs 4 Input lor tap-changer dirtplay :ta:>ahange potentiomete 5 Power supply 6 Disp ay and processing unit 7 Analogue outputs (optional) 8 Binary outputs 9 E-LAN connection (2 x RS485 with repeater function) 10 COM 1, RS232 11 COM 2, RS232 12 COM 3, RS485 (optional) 13 Status signal (life contact) | ||||||||||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||||||||