Bullet magnet Housed Bullet industrial magnets are ideal for the removal of trampiron, for example nuts, bolts, washers and nails etc. from blown or gravity fed pipelines. The magnets are generally installed at ingredient intake points and the primary stages of the process line. The unit is designed to prevent trampiron from damaging expensive process machinery, for example professional mixers, blenders and screw feed manufacturers of conveyors. A high intensity magnetic bullet element is centrally mounted within a stainless steel housing. The design ensures that product flow is unaffected by the magnetic element. All product contact parts are manufactured using 316 grade stainless steel.Data sheet 501 Easy clean grid Head roller Easy Clean grid magnets can be cleaned in seconds. Simply enable the release mechanism, pull the magnetic cores out of the stainless steel tube assembly and the attracted contamination simply falls away. Replace the magnetic cores back into the tube assembly and the grid is in prime magnetic condition once again, the above can be carried out in under 30 seconds! Easy Clean grids offer excellent protection against ferrous and lightly magnetic materials. Many process lines only have a short period of time for equipment to be cleaned making this system an invaluable addition. All product contact parts are manufactured using 316 grade stainless steel.Data sheet 512 Installed at the discharge end of flat or trough belt conveyors suppliers, magneticHead Rollers are designed to remove tramp iron and small pieces of iron that cannot be attracted using either an Overband or Plate magnet due to deep product depths. Used in conjunction with the above mentioned units, Head Rollers magnets will give you the best possible protection against tramp metals. Eclipse Head Rollers are available in two strengths, standard strength for the removal of large pieces of tramp iron or high strength for the removing both large and small pieces of tramp. The shafts of the roller can be machined to suit existing manufacturers of bearing detail ensuring ease of installationand minimal downtime.Data sheet 503 Underflowmagnet These units have been designed to be positioned on the underside of angled chutes to remove tramp type contamination. These 'Primary' magnets are intended to prevent large pieces of ferrous contamination for example nuts, bolts, washers and nails etc from being introduced into process machinery to avoid damage occurring to expensive process equipment. The magnet is supplied complete with a hinge and quick release toggle clamps enabling quick and easy installation of the unit. All product contact parts are manufactured using 316 grade stainless steel. Data sheet 513