SLS Sys EN - 3D Systems - (Version JPG) - Page n° 6 - PDF Catalogue | Technical Documentation

See other catalogues for 3D Systems

Sintering machine, Printer, Software, Prototyping machine, 3D printer

Text version of the page

LaserForm Oven Specifications

Specifications

3D Systems

26081 Avenue Hall

Valencia, CA 91355 USA

telephone 661.295.5600, ext. 2882

fax 661.294.8406

toll free 888.337.9786

email moreinfo@3dsystems.com

www.3dsystems.com Nasdaq: TDSC

France

telephone +33 1 69 35 17 17 Germany

telephone +49 6151 357 303 Hong Kong

telephone +852 2923 5077 Italy

telephone +39 039 68 904 00 Japan

telephone +03 5288 5951 Spain

telephone +34 93 751 49 49


	Temperature	Up to 1070°C
	Electrical	Supply Voltage: 240 VAC, 3 phase, 50/60 Hz
	Power	18.9 kVA peak; 11.3 kVA average
	Inner Size	61 cm diameter x 46 cm high
		(24 in diameter x 18 in high)
	Footprint	1.3 m x 1.52 m (54 in x 60 in)
	Footprint with Clearance	3.35 m x 3.05 m (132 in x 120 in)
	Crane Lift Capacity	136 kg (300lb)
	Nitrogen Requirements	99.998% purity, 30 lpm (64 scfh)
	Facility Cooling and Exhaust Requirements	Remove heat at rate of 63 megajoule/hour
		(60,000 Btu/hour) as well as smoke removal

Warranty/Disclaimer: The performance characteristics of these products may vary according to product application, operating conditions, material combined with, or with end use. 3D Systems makes no warranties of any type, express or implied, including, but not limited to, the warranties of merchantability or fitness for a particular use.

telephone +44 1442 282600

© Copyright 2004 by 3D Systems Inc. All rights reserved. Specifications subject to change without notice. The 3D logo and SLS are registered trademarks and 3D Systems, si2 and LaserForm are trademarks of 3D Systems. All other product names or services mentioned are trademarks or registered trademarks of their respective companies.

P/N 70459 0404

SLS Sys EN - 3D Systems - #6

Sintering machine, Printer, Software, Prototyping machine, 3D printer