3D Modeler - 3D Systems - #8

The InVision® DP 3-D Modeler System includes the InVision® DP 3-D Modeler, InVision® 3-D Scanner, InVision® DP Software, VisiJet® DP material installation kit and a one year warranty.

Specially designed for the dental lab needs Prints wax ups with a proprietary light cured resin Generates as much as 100 units per print cycle

Uses standard electrical outlet

Very smooth surface finish

One of the most precise scanners on the market Uses 2 cameras and 1 laser Scans models in rotation, translation, and tilting Scans virtually any type of die stone Scans single dies in approximately 1 minute

• Simple to use design software - does not require special expertise to operate

• Recreates accurate and fully surfaced 3-D models

• Open system (will export files to any milling equipment)

• Runs on Intel Pentium technology (Dell PC and screen included)

333 Three D Systems Circle Rock Hill, SC 29730 U.S.A.

Tel: 803.326.4080 Toll-free: 800.889.2964 Fax: 803.324.8810

moreinfo@3dsystems.com www.3dsystems.com NASDAQ: TDSC

Warranty/Disclaimer: The performance characteristics of these products may vary according to product application, operating conditions, material combined with, or with end use. 3D Systems makes no warranties of any type, express or implied, including, but not limited to, the warranties of merchantability or fitness for a particular use. Caution: Federal law restricts this device to sale by or on the order of dentists, dental labs and dental assistants if authorized by state law.

The Centers for Disease Control and Prevention recommends that laboratory materials and other items that have been used in the mouth should be cleaned and disinfected before being manipulated in the laboratory, whether an on-site or remote location. These items also should be cleaned and disinfected after being manipulated in the dental laboratory and before placement in each patient's mouth. For further information, please refer to the CDC document 'Recommended Infection-Control Practices for Dentistry, 1993.'

© 2007 by 3D Systems Corporation. All rights reserved. Specifications subject to change without notice. InVision, the 3D logo and VisiJet are registered trademarks of 3D Systems, Inc. Other trademarks or registered trademarks are the property of their respective owners. _{PN 70702 Issue Date - 21 M 07}